Here is how to install Cruise Control to your Auris...
Found this instruction on Toyota Owner's Club Russia
-forum, special thanks to Andron, who took the pictures
and wrote the russian text!
I made some improvements and posted it here, enjoy...
You're gonna need two parts:
Cable
and switch
(You can see the part numbers on the pictures)
Next you have to connect the wire to the switch
After that, remove the cover caps from both sides of the wheel
After removing you will see the following:
(there is a possibility that the caps don't exist, if so, you'll see one screw on both sides of the wheel,
and should just continue to the next step)
Remove the screws (TORX 30).
Pull the airbag covers' upper side towards yourself. DO NOT disconnect the airbag's wire!
Put the switch to it's place from the inside of the right hole (or make the hole in case
you didn't do the "remove the covers from both sides of the wheel" -step because of
not having any covers.
After that just tighten the switch with two M5x10mm, not M6
screws
